SHARP VC-MH71SM
Instrukcja Obsługi

VC-MH71SM ENGLISH.book Page 12 Tuesday, April 20, 1999 10:52 AM

BASIC OPERATION

HOW TO USE

TO MAKE A RECORDING

7. If your VCR has long play facility and you wish
to change the RECORDING SPEED, use the [ / ] to highlight SP. Press [ / ] to select standard play (SP) or long play (LP) as required.
DA T E 21 / 06 --/---/---/-TAPE

8. [See NOTE below]. For VPS/PDC setting use
[/ the [ ] to highlight the final column. Using / ] will select VPS/PDC ON or OFF

P R S T AR T S T OP 02 12 : 00 13 : 00 --:--:---:--:---:--:--

1/2 SP * -------

(D = ON - = OFF).

SET

S P E E D :S P / L P : SE L ECT : CHANGE : ENT ER ME NU : E X I T

9. Press SET to confirm the programme. The
SHOWVIEW menu will reappear. If you wish to enter further SHOWVIEW recordings repeat this procedure.

10. When you have completed entering timer
settings, press MENU to remove the menu from the TV screen.
1/2 DA T E 21 / 06 --/---/---/-P R S T AR T S T OP 02 12 : 00 13 : 00 --:--:---:--:---:--:-SP ----

11. Press TIMER ON/OFF once to place the VCR
in TIMER STANDBY mode. the display. will be shown on

V P S / P DC D : ON - : OF F : SE L ECT : CHANGE SE T : ENT ER ME NU : E X I T

NOTES:
� VPS/PDC is a signal broadcast by some TV stations which adjusts the start and stop time of your VCR recording. This ensures that if there is a change in broadcast time for your programme the VCR will still record the whole programme. It is essential that the start time as it appears in the TV listing is used to program the VCR, as this information is used to identify the VPS/PDC signal corresponding to your programme. If flashes a video tape has not been inserted into the VCR.

� � �

If the video tape is ejected when the VCR tries to record the record protection tab has been removed. During recording, press STOP ( ) to cancel the recording. If there are further recordings to be made, the VCR will return to TIMER STANDBY.

GB-12