Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
Introduction and Installation
3 Remove the adjustment cover, and then adjust the angle of the camera lens.
Adjustment cover
Screwdriver
Angle adjustment lever Left direction (maximum 16°) Right direction (maximum 16°)
Upward direction (maximum 16°) * Be sure to install the adjustment cover after adjusting the angle of the camera lens.
Standard installation height and filming range
Adjust the angle of the camera lens when carrying out installation. Vertical direction (facing the front) Horizontal direction (facing the front)
�
�
(16° upward)
(16° to the right)
�The angle can also be adjusted 16° to the left. Note: � The measurements and angles are for reference purposes and may vary depending on the environment. � If a strong light is against the door station, the visitor�s face may not be distinguishable. Do not place the door station in the following locations. � Where most of the background is the sky. � Where the background is a white wall, and direct sunlight will reflect off it. � Where direct sunlight will shine on the door station. � Depending on where this unit is installed, surrounding noises will cause howling (beeping sound) to occur. Please avoid installing the unit in such a place. � Make sure the back of the door station is not subject to water. Wire type and distance � Wire (between the monitor station and the door station): Type: General cable CAT-3 24 AWG. Distance: Maximum 100 m (about 328 feet).
