Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
1.
INSTALLATION
Connecting VCR with scart cable
Important for the United Kingdom
This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows:
1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 3A, A.S.T.A. or BSI
approved type.
3 Refit the fuse cover.
If your television does not have a scart (AV-Euro) socket, please do not read further here, but turn to the next paragraph �Connecting VCR without scart cable�.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A. Note: * The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. How to connect a plug: The wires in the mains lead are coloured in accordance with the following code: BLUE - �NEUTRAL� (�N�) BROWN - �LIVE� (�L�)
1 The BLUE wire must be connected to the terminal which is
1 Remove the aerial cable plug from your TV set and insert it
into the
2
socket at the back of the video recorder.
2 Plug one end of the aerial cable provided into the 3
socket on the video recorder and the other end into the aerial input socket on your TV set.
3 Insert the plug of a scart cable into the scart socket
marked with the letter �N� or coloured BLACK.
2 The BROWN wire must be connected to the terminal
which is marked with the letter �L� or coloured RED.
3 Do not connect either wires to the earth terminal in the
at the back of your video recorder. Connect the other plug to the TV set.
4 Insert the female plug of the mains cable into the mains
EXT.1
plug which is marked with the letter �E� or by the safety earth symbol \or coloured green or green-and-yellow. Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.
socket
4
at the back of the video recorder.
5 Plug the other end of the mains cable into the wall socket.
