Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 43 (kliknij aby zobaczyć)
Real Time Counter Memory 43
Real Time Counter Memory
Follow the steps below to reset the real time counter to zero at a tape location you want to refer to later.
1 2
Play, fast forward, or rewind a tape to the location that you would like to refer to later. Press the STOP button or the STOP/EJECT button to stop the tape.
POWER
VCR
TV
CABLE /DSS
VCR/TV
1 4
S+ VCR PLU /ENTER
2 5 8 0
3 6
CHANNEL
Press the STATUS/EXIT button. The status display will appear on-screen for about five seconds.
STOP TV STEREO 1:08PM CH10
7
9
+100
MUTE
VOLUME
SPEED TIME SEARCH
1 4 2
�
REW
SLP
1 : 23 : 45
HIFI
STOP
SLOW
PLAY
5
F.FWD +
PAUSE/STILL EJECT
REC/OTR MEMORY
3
While the status display is still on-screen, press the CLEAR button to reset the real time counter to zero.
STOP TV STEREO 1:08 PM CH10
MENU
STATUS/EXIT CLEAR
3
SLP
0 : 00 : 00
HIFI
4
SLP
While the real time counter is still on-screen, press the MEMORY button so that M appears to the left of the real time counter on-screen.
STOP TV STEREO 1:08 PM CH10
Helpful Hints
� The MEMORY button does not function when REPEAT PLAY is set to ON. To turn REPEAT PLAY OFF, see the Helpful Hints on page 41. � To erase a Real Time Counter Memory, press the MEMORY button until the M disappears from the screen. � You may only set the real time counter to zero at one location at a time. If you try to set the real time counter to zero at a second location, the previous real time counter to zero setting will be erased.
M 0 : 00 : 00
HIFI
5
To go to a tape location where the real time counter was reset to zero, press the REW(ind) button or the F.FWD button when playback is stopped. When the tape reaches the point at which the real time counter was reset to zero, the tape will stop. Press the PLAY button to watch the tape.
