ROLAND VS-880EX
Instrukcja Obsługi

Chapter 12 Other Convenient Functions
6. Press [CH EDIT (SELECT)] for the other channel. 7. Repeat steps 2�5 to make the same settings for the other channel. 8. Press PARAMETER [ ]. �Ofs Level =� appears in the display. 9. Rotate the TIME/VALUE dial. Ofs Level (Offset Level) Adjust the overall volume level (0�127) while maintaining the volume balance of the two channels. This will operate linked with the channel fader of the oddnumbered channel. 10. If you wish to assign the output of a source or track to the AUX bus, press PARAMETER [ ] to make the display read �AUX Sw =.� 11. Rotate the TIME/VALUE dial. AUX Sw (AUX Switch) This sets how the signal is sent to the AUX bus. Here, select �PstFade.� Off: The signal is not sent. (This will not be output from the AUX jacks.)

Adjusting the Pan
When Channel Link is on, this adjusts the total leftright balance while preserving the pan settings for both channels. If you want to adjust the pan for each channel independently, use the following procedure. 1. Press [CH EDIT (SELECT)] for the channels whose pan settings you wish to adjust. 2. Press PARAMETER [ ][ ], so that �MIX Sw =� appears in the display. 3. Rotate the TIME/VALUE dial. MIX Sw (Mix Switch) This selects the bus to which the source or track output will be assigned. For this example select �On.� On: The source or track will be sent to the mix bus. Set this to �On� when, for example, you simply want to mix the inputs without recording the source. However, the sources that are assigned to the RECORDING bus are disabled. The source or track will not be assigned to the mix bus. If it is not assigned to a recording bus either, then that source/track will not be output anywhere. 4. Press PARAMETER [ appears in the display. 5. Rotate the TIME/VALUE dial.
Mix Balance (In the example, L63)
CONDITION MARKER#

Off:

PreFade: The signal before passing through the channel fader is sent. PstFade: The signal after passing through the channel fader is sent. 12. Press PARAMETER [ ]. �AUX Level=� appears in the display. 13. Rotate the TIME/VALUE dial. AUX Level (AUX Level) This adjusts the level (0�127) of the signal sent to the AUX bus. 14. Press [CH EDIT (SELECT)] for the other channel. 15. Repeat steps 11�14 to make the same settings for the other channel. 16. Press [PLAY (DISPLAY)]. Return to Play condition.

], so that �MIX Bal�

TIME
dB

0 4 12 24 48 INPUT TRACK AUX MASTER

MIX Bal (Mix Balance) Adjust the pan (L63�0�R63) of the signal that is output to the mix bus or the recording bus. 6. Press [CH EDIT (SELECT)] for the other channel. 7. Repeat steps 2�5 to make the same settings for the other channel.

150