|
|
|
Kto jest w sklepie?
Sklep przegląda 5750 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Installation
Level the washer
To ensure smooth operation, the washer must be level. Failure to level the machine can result in increased water and energy consumption, loud noise during the spin cycle or "walking" across the floor during use.
^ Unscrew each of the four feet as much as necessary by turning both the foot, 1, as well as the locking ring, 2, to the left using a screwdriver. ^ Remove the support and stand the machine on its feet. ^ Check that the machine stands level. ^ Repeat the above procedure until the machine stands level. Adjust the four leveling feet The washer is leveled by adjusting the four feet: ^ Tip the machine slightly and place a support, such as a block of wood, underneath it. ^ Once level, hold the foot, 1, immobile with a wrench. At the same time, turn the locking ring, 2, to the right using a screwdriver.
,All four locking rings must be
tight against the bottom of the machine. In addition, check to see that the feet were not inadvertently unscrewed while tightening the rings. Operating a machine that is not level or whose feet are not tight may cause damage to both the machine and its surroundings.
extremely heavy. When tipping the machine, be careful that it does not slip.
,CAUTION: The washer is
40
|
|
|
> |
|
