Installation
Remove the transport bolts
1. Slacken the four bolts with the spanner supplied. 2. Remove by hand. 3. Grip the bolt and remove it through the large aperture. 4. Seal the resulting holes using the plastic caps supplied; insert the covers in the wide part of the hole and slide them toward the narrow part until they click into place. 5. Retain transit bolts.
Adjusting the feet
Small unevennesses in the floor can be compensated for by screwing the four appliance feet up or down (never use pieces of wood, cardboard or similar material): 1.Loosen the locknut using the wrench provided. 2.Adjust the height of the foot by hand. 3.Tighten the locknut anticlockwise towards the washing machine. If the appliance is to be installed on a wooden floor, place it on a sheet of plywood at least 60x60 cm in size and 3 cm thick. Secure the plywood sheet to the floor.
Secure the washing machine before transporting it:
1. Pry off the plastic covers with a screwdriver, slide them in the opposite direction of the arrow and remove. 2. Refit the transit bolts in reverse order.