Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
INSTALLATION
POSITION
Place the freezer horizontally on a firm surface, resting on all four plastic feet. Use a wooden block or similar object to compensate for any bumps/holes in the surface. The room should be dry and adequately ventilated. If the room temperature exceeds 32°C, or falls below freezing point, the freezer will not function as it should. Do not place the freezer close to sources of heat, radiators, chimneys, etc., and do not place the freezer in direct sunlight. If the freezer has been handled standing on end it should be allowed to stand in normal position for about 12 hours before switching it on. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
Appliance Description
Control Panel
1 2 3 4 temperature regulator green mains operating light fast freeze switch with amber light red temperature warning light
Starting up
Please clean the appliance interior and all accessories prior to initial start-up (see section: �Cleaning and Care�). Insert the mains plug of your chest freezer into the mains supply. Your appliance is then operational. The green mains operating light (2) and red temperature warning light (4) show, and the acoustic temperature warning sounds. The green mains operating light indicates operation and must continuously show. The red temperature warning light tells you that the storage temperature has not yet been attained. If you additionally operate the fast freeze switch (3), the amber pilot light in the switch (3) illuminates, and the refrigerating unit operates in continuous mode. When the fast freeze switch is pressed, the acoustic temperature warnin immediately stops. If you switch off the fast freeze switch (3) when the red temperature warning light (4) has gone out, the amber light goes out. The red temperature warning light (4) and acoustic temperature warning give an alarm if: the storage temperature has not yet been reached (starting up). the minimum storage temperature is no longer being maintained (fault).
4
