SHARP XEA301
Instrukcja Serwisowa

3) PRINTER TEST
1 Key operation 102 3 RCPT/PO 2 Test procedure

5) MODE SWITCH TEST
1 Key operation 105 3 RCPT/PO 2 Test procedure

OP display

R/J

PRINTER

PGM
OP display
Enlargement

MODE 105

SW

PGM X

MODE: PGM_VOID_OFF_OP X/Z_REG_MGR_X1/Z1_X2/Z2__PGM X:1 2 9 3 4 5 6 7 1
The above X must be read in the correct order. (If the contact is open, 9 will be displayed.)
5 lines of 24 digits are printed.

3 Check: The display during testing and the content of the completion print.

At the receipt side, the logo is also printed and the receipt is issued. 3 Check that: The print is free from contamination, blur, and uneven density. 4 End of testing The test will end automatically.

4 End of testing When the test ends normally When an error occurs: E�~�

105 105

6) PRINTER SENSOR TEST
1 Key operation 106 3 RCPT/PO 2 Test procedure Check the status of the paper end sensor and head up sensor.

4) KEYBOARD TEST
1 Key operation _ _ _ _104 3 RCPT/PO 2 KEY check sum code 2 Test procedure The keyboard is checked using the sum check code of the key code. If the sum check code is not entered, the check is made using the sum check code of the default keyboard arrangement The sum check data for each model is entered to the front 4 digits of the DIAG code, and that data is compared with the key data added until the final key (CA/AT) is pressed. Both data are the same, the test ends, printing the number given below. If both data are different, the printer prints the error message.

OP display

R/J 106

SENSOR

PGM XY

3 Check the following. X: 1 - Paper present at the receipt side O - No paper at the receipt side Y: 1 - Paper present at the journal side O - No paper at the journal side 4 End of testing

OP display

KEY 104

BOARD

PGM

You can exit the test mode by pressing any key and the printer prints the following.

106
KEY CODE

7) CLOCK TEST
1 Key operation 107 3 RCPT/PO 2 Test procedure

3 Check: A) The content of completion print 4 End of testing When the test ends normally: When an error occurs: Note: Calculation of key sum check data Hard codes (hexadecimal number) at the position (excluding feed key) where there is an input data contact are added. However, the end key (TL) is not added. This data to which hard codes have been added is converted into a decimal number value, which will become the sum check data that will be entered when DIAG is started.
XE-A301V

104
E�~�

OP display

104

T I ME R 104

CHECK

PGM

Hour

Min.

Sec.

Blinks at an interval of 0.5 sec.

3 Check that: ��� blinks and the clock counts up.

DIAGNOSTIC PROGRAM

� 11 �