|
Dla tego produktu nie napisano jeszcze recenzji!
(Continued)
s ASPM (Auto Station Program Memory)
At first, it is recommended that you store stations in memory using ASPM. (This memory can be used for PTY searches.) When the ASPM button is pressed whilst tuned to the FM band, the RDS (Radio Data System) function will automatically search for new RDS stations. Up to 30 stations can be stored in memory. (If you have already stored some stations in memory, the number of new stations you can store will be less.)
� After scanning, the number of stations that have
been stored in memory automatically will flash for 4 seconds.
1 3 2 4
Notes: q Only RDS stations can be stored in memory. q If the same station is broadcasting on different frequencies, the transmission with the strongest broadcast frequency will be stored in memory. q Any station which has the same frequency as one which has been already stored in memory will not be stored again. q If a 30th station is stored in memory during a scan, the scanning will stop at that station. The number of stations will flash for 4 seconds. q If no stations have been stored in memory, �0MEMORY� will appear for about 4 seconds. q If 30 stations have already been stored in memory and the ASPM button is pressed, �ASPM� will flash for 4 seconds and the scan will be aborted. If you want to redo the ASPM operation from the beginning, erase the preset memory, and then perform steps 1 - 4.
1 Press the ON/STAND-BY button to turn the
power on.
2 Press the FUNCTION button until �FM� or �AM�
appears in the display.
3 Press the BAND button to select the FM ST or
FM band. q Even if FM monaural is selected, if ASPM scanning is being performed, the unit will enter the FM stereo mode.
To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations. q The stations that have already been stored in memory will be kept there.
4 Press and hold down the ASPM button for at
least 3 seconds.
� After "ASPM" has flashed for about 4 seconds,
scanning will start. (87.50 - 108.00 MHz)
To erase one of the contents of preset memory:
1 Press the VOLUME/JOG button. 2 Turn the jog dial to select the preset channel
number you want to erase.
3 Press the MEMORY/SET button. 4 Within 5 seconds, press the TUN CLEAR but� When an RDS station is found, �RDS� will appear first, and then �MEMORY� and the preset channel number will flash for 2 seconds. Finally, the station will be stored in memory. ton.
To erase all of the contents of preset memory:
Perform steps 1 - 3 in the section �RESETTING THE MICROCOMPUTER�, on page 31.
21
60H/70H(SUK)18-22 21 00.1.5, 11:40 AM
|
