DIGITECH XP-200
Instrukcja Obsługi

11. Mode/(Hold)Program - This button is used to engage the User mode for the XP-200. The beauty of the the User mode is that the XP-200 will give you the opportunity to store up to 6 of your favorite Factory programs within the same area. This will save you the toe-tap dancing ritual of accessing programs. To put the XP-200 in User mode, simply press the Mode button on the front of the unit. To store Factory programs in the User program mode, The procedure is as follows: First, select the Program to be stored. Press and hold the <MODE/(HOLD)PROGRAM> button. The display will read: U1. From here, use the <UP/(Hold)DOWN> footswitch to select which user location. Now just press the <MODE/(HOLD) PROGRAM> button to save. The display will read: SA to confirm, then return to Program mode. 12. AC Line Input - Connect the power adapter here. Use only the included PS 750 power supply.

Tuner Mode
To access the Tuner mode, press and hold the <BYPASS/(Hold)TUNER> footswitch until tu appears in the display. The currently played note is displayed in the left character of the status display window, while the intonation is displayed in the RIGHT character of the window. When the input note is in tune, the display will read:

When the note is flat, the intonation character will rotate counter clockwise as shown below:

When the note is sharp, the intonation will rotate clockwise as shown below:

The faster the character spins (either clockwise or counter clockwise), the more out of tune the note is.

Bypass Mode
To place the XP-200 in Bypass mode, press the <BYPASS/(Hold)TUNER> footswitch. When the XP is in Bypass mode, the Expression pedal is inactive, but programs can still be selected using the <UP/(Hold) DOWN> footswitch while the unit is in bypass. The new program is loaded once Bypass mode is exited. When the XP is in bypass mode, the display will read:

Factory Reset/Pedal Calibrate
To reset the User programs to their factory settings and calibrate the expression pedal, press and hold the <BYPASS/(Hold)TUNER> foot switch and apply power to the unit. Wait until the letters rS appear in the display and release the foot switch. The display will now read: Pd and CA , indicating that you are in Pedal calibrate mode. Once Pb appears, rock the pedal back and press the <BYPASS> foot switch. When PF appears, rock the pedal forward and press the <BYPASS> foot switch. SA will next appear in the display to confirm the pedal is now calibrated.