÷ When the power plug is first connected, the unit automatically enters the demo (demonstration) display mode. Press the STANDBY/ON switch to cancel the demo mode, then set the clock display to the current time. ÷ Set the clock when it is incorrectly set, or when power to the unit is cut. ÷ The time is displayed as a 24 hour clock. ÷ The clock cannot be set with the remote control unit.
1
Example: Setting the clock to 6:40 1. Press the TIMER/CLOCK ADJ button. 2. Turn the S. M. JOG until �CLOCK ADJ� is indicated on the display. 3. Press the SET button.
2
ND MORPHING
3
SOU
4. Turn the S. M. JOG to set the �Hour� then press SET button. (�6� is selected in the example.) 5. Turn the S. M. JOG to set the �Minute� then press SET button. (�40� is selected in the example.)
÷ After connecting to an AC outlet, be sure to set the time. Timer playback is not possible unless the time has been set. ÷ The time display will flash when the power is restored following a power failure, or if the power cord has been disconnected. In this case, be sure to set the present time again.
JOG
\
4
UND MO
RPHIN
G JO
7 To display the clock
G
SO
\
Press the DISPLAY button. Clock indications disappear after about 5 seconds.
