Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
Attaching the front panel
Getting Started
Resetting the unit
Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the reset button with a pointed object, such as a ball-point pen.
Attach part A of the front panel to part B of the unit as illustrated and push until it clicks.
B
A
Reset button Note Pressing the reset button will erase all the memorized stations.
EN
Detaching the front panel
The front panel of this unit can be detached in order to prevent the unit from being stolen.
Notes � Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. � Do not press the front panel hard against the unit when attaching it to the unit. It can easily be attached by pressing it lightly against the unit. � When you carry the front panel with you, put it in the supplied front panel case. � Do not press hard or give excessive pressure to the display windows of the front panel. � Do not expose the front panel to direct sunlight, heat sources such as hot air ducts or leave it in a humid place. Never leave it on the dashboard etc. of a car parked in direct sunlight where there may be a considerable rise in temperature inside the car.
Caution alarm
If you turn the ignition key to the OFF position without removing the front panel, the caution alarm will beep for a few seconds (only when the POWER SELECT switch is set to the A position).
1 2
Press (OFF). Press (RELEASE) to open up the front panel, and detach the panel by pulling it towards you.
(RELEASE)
Notes � Be sure not to drop the panel when detaching it from the unit. � If you press (RELEASE) to detach the panel while the unit is still turned on, the power will be automatically turned off in order to protect the speakers from being damaged.
