4 Select the type of characters to be used for the title.
English
DISPLAY /CHARA
\ Upper-case letters/symbols
â� â�
Lower-case letters/symbols
Each time this is pressed, the character type changes. (The input characters appear in the display window.)
Numbers
For details, refer to the character layout table on page 44.
5 Input the title (using up to 32 characters).
SET
To return to a previous character
To advance to a later character 2 Enter the selection.
1 Select the characters.
DISC
TITLE
MD
L R 40 30 20 15 10 6 3 0
� � �
�
If the wrong character has been input, clear it using the CANCEL button. The preferred title is input by repeating steps 4 and 5. To clear a particular character which has been input, use the 1 button to align the cursor with the character, and press the CANCEL button. Then, select the correct character and press the SET button. In this way, the character can be corrected. If the ¡ button is pressed when the cursor is positioned as shown in the figure above, a space will be input.
6 Press the TITLE button.
TITLE
� �
The title now appears after �EDITING.� It is stored in the memory IC. To give other tracks titles, repeat the procedure starting with step 2.
7 Eject the MD. \ The editing mode is now exited.
� � After �UTOC WRITING� is displayed, the MD is ejected. The data in the memory IC has been recorded on the MD.
The editing mode can also be exited by pressing the POWER button in step 7 to turn off the power.
In step 3, only those numbers of the tracks which are recorded on the MD can be selected by the jog dial as track numbers. To stop operation at any time Press the TITLE button in step 2, 3, 4 or 5. Up to 5 characters which are being input can be displayed. When the sixth character is input, the characters are scrolled forward so that the first character is cleared from the display. Do not disconnect the power cord or subject the unit to the vibration while �UTOC WRITING� appears. Doing so may make it impossible to play the MD.
