Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 37 (kliknij aby zobaczyć)
Basic Operations
English
Adjusting the surround sound
You can select the simulated surround effect depending on the disc contents. If you connect the unit to your stereo system, you can enhance sound quality and produce a greater surround effect.
Français
To simulate the surround sound [3D PHONIC]
7 During playback
1 2
Press
3D PHONIC
.
Within 10 seconds, select the desired effect mode by pressing .
3D PHONIC
ACTION* DRAMA THEATER OFF * When you play the DVD disc recorded in Dolby Digital and contains more than 3 channel sound, ACTION does not appears. Selected effect mode
3
To erase the 3D PHONIC screen, press . The 3D
ENTER
Press to adjust the effect level.
You can adjust the effect level in 5 steps. Toward L : Reduce the effect Toward H : Enhance the effect
3D PHONIC
PHONIC screen disappears if there are no operations for more than 10 seconds.
Effect level
NOTES ¶
The sound effect (3D PHONIC) is possible only on discs which are recorded in DOLBY SURROUND or DOLBY DIGITAL. However, some DOLBY SURROUND or DOLBY DIGITAL discs do not contain the rear sound signal, in this case, the setting can be changed but the sound effect cannot be obtained. You can change the setting of the discs which do not contain the rear sound signal, but the sound effect cannot be obtained. The sound effect is not possible, and will not work even if set when the unit outputs the DTS or Dolby Digital bitstream signal from the DIGITAL OUT jack. The sound effect will not be set or operate, even if 3D PHONIC is pressed, on the sound of DVD discs recorded in Linear PCM. When you set the 3D PHONIC function to on, the DOWN MIX and COMPRESSION setting in the PREFERENCE 2 display and settings in the SPK.SETTING are disabled.
¶ ¶ ¶ ¶
33
Basic
THEATER
L
H
operations
Each time you press 3D PHONIC , the effect mode changes as follows:
