...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 63 (kliknij aby zobaczyć)
5
6
7
8
4 AMP Module L-2CH
1
the AMP module L-2CH can be removed without removing the RX module. (Shown as step �.)
A
2
Remove the two screws.
2
Chassis section
3 4 5 6 7
Remove the three screws. Remove the two push rivets. Remove the one screw. Put off the PCB angle for a while. After removing POWER ASSY by removing one screw, remove the AMP Module L-2CH by removing the three connectors. Barrier
3 3
4
3
B
2
Rear view
7 7 7 6 5 7 7
PCB Angle
C
Before shipping out the product, be sure to clean the following positions by using the prescribed cleaning tools: Position to be cleaned Fans Cleaning tools Cleaning paper : GED-008 AMP Module L-2CH
Able to input signals using the jumper wire for service. At that time remove the RX MOD ULE. (Refer to 7.1.3 DIAGNOSIS FOR AMP SECTION)
D