Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
INSTALLATION
IMPORTANT
It is essential that a competent installer is employed to fit this appliance. The manufacturer will not accept liability, should the above instruction or any of the other safety instructions incorporated in this book be ignored. On the end of the shaft, which includes the GJ 1/2" threaded nut, adjustment is fixed so that the washer is interposed between the components as shown in Figure 1. Screw the parts together without using excessive force, orientate the adjustment in the desired direction and then lock it all together. Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. The connection should be suitable for connecting to RC 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Ensure that the main connection pipe does not exert any strain on the hob. Rectangular cut-out size for hob
58
0
51
0
0 55
47
0
55
m
in
.
FO 2106
Fig. 2
FO 0814
FO 0264
Fig. 1
A) End of shaft with nut B) Washer C) Adjustable join It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe. Failure to ensure the correct assembly will cause leakage of gas.
If using flexible metallic pipes, be careful they
do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven.
