Setting the hob for the new gas type
1. If necessary, activate the hob by touching the main ON/OFF Control for about 3 seconds.
2. Touch the Timer Control repeatedly to select the auxiliary burner (front left burner) on the burner selection display .
3. Touch the Increasing Control and hold the finger on it until the value 99 appears on the time display. Then, touch the Decrasing Control and hold the finger on it until the value 80 is displayed.
4. Then, touch the Increasing Control until 83 is displayed. At this point, the hob is set to the �Gas Change� mode and the current gas setting appears on the display: - n0 stands for gas G20 (20 mbar) - n1 for gas G30 (28-30/37 mbar). IMPORTANT: setting n2 does not allow the hob to function. 33
