AEG ZJD1219
Instrukcja Obsługi

Drying only
Warning! Do not exceed the maximum laundry loads: - 2.25 kg for linen and cottons - 1.5 kg for synthetics. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. 1. Load the laundry 2. Depress the ON/OFF button to switch the machine on. 3. Select the drying programme (for cotton or synthetics). 4. Depress the Drying Time button until the time you want appears in the display. The corresponding light comes on. 5. Press the START/PAUSE button to start the programme. 6. At the end of the cycle, turn the programme selector dial to Reset O and press the ON/OFF button again to switch the appliance off. 7. Remove the laundry.

Automatic washing and drying (NON-STOP programme)
Warning! For NON-STOP programmes, it is also essential not to exceed the maximum load sizes of 2.25 kg for cotton and 1.5 kg for synthetics. 1. Load the laundry. 2. Add detergent and fabric softener. Do not use dosing device/ball when carrying out the NON-STOP programme because the plastic material is not designed to withstand the high drying temperature. 3. Switch the machine on by depressing the ON/OFF button. 4. Select the wash programme. 5 Select eventually the required options by means of the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid a too long drying time so saving energy. In any case the reduction of the spin speed is only possible after selecting drying. The lowest values you can select are the following: - 900 r.p.m. for cottons and 700 r.p.m. for synthetics Select the drying time. Start the programme by depressing the START/PAUSE button. At the end of the programme, turn the selector dial to Reset O and press the ON/OFF button again to switch the machine off. Remove the laundry.

6. 7. 8.

9.

13