Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
The three blinking dashes will also appear when you press the ON/OFF button to switch the machine on, if the previously selected cycle has been erased.
0
--Important! The first time you use the machine, when you switch it on, it may display a blinking zero. This is due to the fact that the machine has performed a washing cycle during the manufacturer�s inspection tests, and this cycle has not been erased after its completion. � Delay start (Arranque retardado), a time value indicated in hours and selected by means of the relevant button (max 23 hours).
� Duration of washing programme in hours and minutes, after you have selected a programme.
2.05
While the programme is running (after you have pressed the START/PAUSE button), the displayed time value decreases by one unit every minute. � Drying time: the selected drying time is displayed in minutes or hours and minutes (max 130 mins). After starting the programme, the remaining time is updated every minute.
The delay time is displayed for 3 seconds, then the duration of the selected programme reappears. After you have pressed the START/PAUSE button, the countdown begins, and the delay time value decreases by one unit every hour and then, when remain the last 2 hours each 30 min. You can delay the start of the selected programme by up to 23 hours in one hour intervals. � An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
1.25
� The machine has stopped with water in the tub, at the end of a programme with the RINSE HOLD (AGUA EN LA CUBA) option: this is indicated by a flashing zero. � The machine has completed the programme: this is indicated by a blinking zero. At the same time, the door locked light goes out. The zero will reappear when you switch the machine on, unless the previous programme has been erased by means of the RESET (ANUL.) button.
