Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
E
Fig. 8 Position the runners (E) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing
Fig. 11 In case of side �xing of the appliance, it will be suf�cient to loosen the screws �xing the brackets (F) and to position them as shown in Fig. 11. Finally, mount the cover (G).
G H
20mm
G
D317
D285
the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws.
8mm
PR34
Fig. 9 Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 10 Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment
PR35
of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly.
