Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
� Delay start, a time value indicated in hours and selected by means of the relevant button (max 23 hours).
--� Duration of washing programme in hours and minutes, after you have selected a programme.
2.05
While the programme is running (after you have pressed the �Start/Pause� button), the displayed time value decreases by one unit every minute. � The washing machine has stopped with water in the tub, at the end of a programme with the �Night cycle� option: this is indicated by a flashing zero. � The washing machine has completed the programme: this is indicated by a flashing zero. At the same time, the door locked light goes out. The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by means of the �Skip Reset� button.
The delay time is displayed for 3 seconds, then the duration of the selected programme reappears. After you have pressed the �Start/Pause� button, the countdown begins, and the delay time value decreases by one unit every hour and then, when remain the last 2 hours each 30 min. You can delay the start of the selected programme by up to 23 hours in one hour intervals. � An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible warning signal.
0
Important! The first time you use the washing machine, when you switch it on, it may display a flashing zero and give an audible warning signal. This is due to the fact that the washing machine has performed a washing cycle during the manufacturer�s inspection tests, and this cycle has not been erased after its completion. 8
� An alarm code indicates a fault in the machine operation (see the relevant chapter on page 20).