Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
POSITIONING
Height adjustment
The height of the appliance is adjustable by 50 mm. in order that the lower doors line up with existing kitchen units.
820 870
Before installing the appliance between units, adjust the height of the feet and rear wheels. The wheels are factory set for a work top height of 820 mm. To align the appliance to work top height of 870 mm, raise it by adjusting the feet with a spanner, then remove the wheels and refit them in the lowest position.
820
870
REAR EDGE RIGHT HAND SIDE PANEL
FRONT EDGE
Fitting the side panels
� Fit the brackets onto the panels in the positions shown in the diagram. The dimension of 260* mm is allowed for fitting a 100 mm plinth below the panel. For different plinth sizes, increase the dimension of 260* mm accordingly.
15
27,5 997
820
INSIDE FACE
15 280
82,2
520,8
37, 541 5
260*
� �
Rest the panels against the appliance. Fit the rear brackets, taking into account the thickness of the panels (maximum width of unit 900 mm). For a correct alignment make sure that the distance between the appliance and the cabinet is of 45 mm. Secure the panels at the front. Check the alignment of the doors loosing the fixing screws and by means the adjustment bushes. Tighten the clamp screw on the bottom hinges of the doors.
45
