3COM 09-0727-000
Podręcznik Użytkownika

Removing the 3C589C PC Card

2-5

3 To use the BNC connector on the 3C589C-COMBO cable, attach the BNC connector to the network cable, as shown in Figure 2-6.
E S M o
R T

E N + t

A B 8 . 8
ID S

E S IN P

IS H T

a 1 nd
E

T

BNC connector for network

Figure 2-6 Attaching the BNC Connector to the Network

Once the PC Card is connected to the network, the installation is complete. To con�gure the 3C589C PC Card, go to Chapter 3 if you are on a Novell NetWare network. If you are on any other network operating system, go to Chapter 4, Installing the NDIS Driver.

Removing the 3C589C PC Card
The PC Card can be removed whether the power to the PC is ON or OFF. Follow these steps to remove the PC Card: 1 Disconnect the cables from the 3C589C PC Card. 2 Remove the PC Card from your PC. Many PCs have a button or lever to assist in removing the PC Card. Refer to the instructions provided in your PC manual. 3 Store the PC Card in its original or similar packaging. This completes the procedure for removing the PC Card.

®

62 3 C5

U

PC Card connector
®

A t

d inaC kr C rPL m hdM e oe

0 2 d e nL er tE mh e

II
®

Network cable