Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
ASSEMBLY
NOTE: Make sure unit is assembled correctly as shown in this manual. NOTE: Fit throttle wire in groove of lower harness clamp before tightening screws. S Insert two screws into the screw holes. S Secure harness clamp by tightening screws with a hex wrench. Adjusting the harness
S At the front of the harness is an easily accesible quick release. Use the quick release in any emergency situation that requires you to free yourself from the machine and harness.
Fitting the handlebar
S Remove the screw at the rear of the throttle handle. S Slide the throttle handle onto the right side of the handlebar (see illustration). S Align the screw hole in the throttle handle with the hole in the handlebar. S Refit the screw in the hole in the rear of the throttle handle. S Screw the screw through the handle and handlebar. Tighten the screw. S Fit the mounting components as shown.
Spreading the load on your shoulders
S A well-adjusted harness and machine makes work much easier. S Put on the harness. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.
S The handlebar mounting must be fitted between the arrows on the shaft. S Tighten the screws with a hex wrench.
NOTE: It may be necessary to relocate
the harness clamp on the shaft for proper balancing of unit.
Fitting the harness
WARNING: When using a brushcutter, it must always be hooked securely to the harness. Otherwise, you will be unable to control the brushcutter safely. This can result in injury to yourself or others. Never use a harness with a defective quick release.
Proper harness and handlebar adjustments must be made with the engine completely stopped before using unit.
Fitting the harness clamp
S Place the upper harness clamp over the shaft and position the lower harness clamp under the shaft. Align the upper and lower clamp screw holes. Clamp must be fitted above the arrow on the shaft (see illustration). 10
