WHIRLPOOL 12M52TA
Instrukcja Obsługi

Electrical Requirements
Electrical Grounding Instructions This appliance is equipped with a three-prong grounding plug for protection against possible shock hazards. If a twoprong wall receptacle is encountered, the customer is required to contact a qualified electrician and have the twoprong wall receptacle replaced with a properly grounded three-prong wall receptacle in accordance with the National Electrical Code. Room air conditioners are designed to operate according to requirements on the nameplate and as shown in Figure 1. Fuse or circuit breaker ratings must be according to the fuse instruction label and as shown in Figure 1. Do not plug models marked �Use on Single Outlet Circuit Only� into a circuit with another appliance or light fixture.

Safety Features
This room air conditioner is equipped with an electronic control to improve comfort and ensure reliability.

Compressor Lockout To extend the life of the compressor a three minute time delay will occur when:
� � � Electrical power is first supplied to the unit The thermostat is turned down immediately after the compressor stops running. The Fan Control is quickly turned from FAN ONLY to COOLING mode or vice versa.

WARNING
To avoid death, personal injury or property damage due to electrical shock, this unit must be grounded. Do not under any circumstances cut or remove the round grounding prong from the plug. Do not use a two-prong adapter.

Low Voltage Protection This unit is equipped with �brownout� protection. In case of an extreme brownout, the Amana control will interrupt power to the unit to prevent compressor failure. When the line voltage reaches at least 180 VAC, the control will reenergize your unit. Note: A compressor lockout will occur after the unit is re-energized.

WARNING
To avoid death, personal injury or property damage due to electrical shock, do not use an extension cord. Do not pinch the power cord. Do not remove the warning tag from the power cord.

Advantages of Amana�s Electronic Controls
�Digital Temperature Setting
- Temperature can be set from 16°C to 32°C in 1°C increments

RECEPTACLE

PLUG

�Digital Temperature Display
- Shows indoor room temperature in FAN ONLY mode - Shows desired temperature setting in other modes �Computer Memory that Remembers - The unit remembers the last settings used when last turned on.

�TempAsure® Thermostat
250 V - 16 AMP

- Maintains set temperature within 1.0°C for maximum comfort

�Smart Cool �Energy Saver with TempAsure® air sampling

Figure 1

�Delay Timer

2