SHARP 14VTN10T
Instrukcja Serwisowa

14VT-N10T(S)

INSTALLING THE MASTER CAM (AT REAR SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as shown below. 2. Place the master cam in the position as shown below.
E-ring (XRESJ30-06000) Master cam

REPLACEMENT OF LOADING MOTOR
� Removal

Apply grease Apply grease

Fully turn clockwise

No grease Fully turn counterclockwise Face the wide tooth side ward

Figure 1-44-1. Note: See the figure below for the phase matching between the master cam and the casecon drive gear. 3. Finally fix with the E-ring. � Replacement 1. Remove the loading motor, and install the replacement loading motor as shown below.

Figure 1-45.

Master cam

Casecon drive gear 10.2 +0.2 mm
�0.2

Half-round notch Round mark

When installing the master cam, align the casecon drive gear round mark with the half-round notch of master cam.

Figure 1-46.

Figure 1-44-2.

The loading motor pressing-in must be less than 14.7 N (15 gf). Adjust the distance between motor and pulley to 10.2 +0.2 mm).
�0.2

36