SHARP 29FL91M
Instrukcja Serwisowa

29FL91M

DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
WAVEFORM MEASUREMENT CONDITIONS:

1. The unit of resistance "ohm" is omitted. (K=k�=1000�, M=M�) 2. All resistors are 1/16 watt, unless otherwise noted. 3. All capacitors are µ F, unless otherwise noted. (P=pF=µµF) 4. (G) indicates ±2% tolerance may be used. 5. indicates line isolated ground.
VOLTAGE MEASUREMENT CONDITIONS:

1. Photographs taken on a standard gated color bar signal, the tint setting adjusted for proper color. The wave shapes at the red, green and blue cathodes of the picture tube depend on the tint, color level and picture control. 2. indicates waveform check points (See chart, waveforms are measured from point indicated to chassis ground.)
å ç

1. All DC voltages are measured with DVM connected between points indicated and chassis ground, line voltage set at 120V AC and all controls set for normal picture unless otherwise indicated. 2. All voltages measured with 1000µ V B & W or Color signal.

AND SHADED ( ) COMPONENTS = SAFETY RELATED PARTS. MARK= X-RAY RELATED PARTS.

This circuit diagram is a standard one, printed circuits may be subject to change for product improvement without prior notice.

WAVEFORMS

11.0 Vp-p

22.1 Vp-p

3 1.0Vp-p

40.75 Vp-p

55.0 Vp-p

65.0 Vp-p

70.85 Vp-p

812.5 Vp-p

932 Vp-p

056 Vp-p

q2.0 Vp-p

w0.8 Vp-p

e160 Vp-p

r14 Vp-p

t1150 Vp-p

y450 Vp-p

u250 Vp-p

i29.5 Vp-p

o3.0 Vp-p

p3.0 Vp-p

a3.0 Vp-p

s130 Vp-p

d125 Vp-p

f130 Vp-p

14