Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.The following connection diagrams show you how to connect them.
Connect the RF cable 1 to the RF socket x of your video recorder. Connect another RF cable 2 from the output j of your video recorder to the input x of your TV. Better playback quality can be obtained if you also connect the Video, Audio Left and Right (only for stereo equipment) cables 3 to the VIDEO, AUDIO L/Mono and R input AV2 IN. Note: in case of mono equipment, only the left loudspeaker reproduces sound. Use a mono to stereo adaptor (not supplied) for sound reproduction via all internal loudspeakers.
75
Monitor
VIDEO L/Mono AUDIO
out
AV 1
in
AV 2
in
Y
The MONITOR OUT connectors can be used for daisy chaining or to record programmes from your TV. See Record with your video recorder, p. 18.
S-VIDEO
Pb
3
R
Pr COMPONENT VIDEO INPUT
S-VHS-Video quality with a S-VHS video recorder is obtained by connecting the S-VHS-Video cable with the S-VIDEO input instead of connecting the video
recorder to the
OUT j x
VIDEO
input. (See the instructions of your video recorder.)
VCR
If the cables 3 are not used the following steps are required: Search for and store the test signal of the video recorder
Unplug the RF cable 1 from the RF socket x of your video recorder. Switch on your TV and put the video recorder on the test signal or play a prerecorded tape (See the handbook for your video recorder.). Search for the test signal of your video recorder in the same way as you searched for and stored the TV signals. See Installation, Store TV Channels, Manual Tuning, p. 5. Store the test signal under programme number 0 or between 90 and 99. Replace the RF cable in the RF socket x of your video recorder after you have stored the test signal.
