PHILIPS 29PT9007/58
Instrukcja Obsługi

Tips
Poor picture The proximity of mountains or high buildings may be responsible for ghost pictures, echoing or shadows. In this case, try manually adjusting your picture: see Fine Tuning (p. 5) or change the direction of the outside aerial. Does your aerial enable you to receive broadcasts in this frequency range (UHF or VHF band) ? There may be interference if the TV set is too close to equipment that is not earthed (sound system, cordless phone, ...) or if a piece of equipment connected to the side connectors is operating at the same time as a piece of equipment connected to EXT1 or EXT2. Switch off one of the 2 pieces of equipment. No picture Have you connected the aerial properly ? Have you chosen the right system ? (p. 5) Are the contrast and brightness correctly tuned? Reset the factory settings with the SETUP menu (p.11). A wrong SCART or aerial socket connection is often the cause of poor picture or sound problems. Check all the connections. No sound If on certain programmes you receive a picture but no sound, this means that you do not have the correct TV system. Modify the System setting (p. 5). Is the sound interrupted with the mute m key ? Teletext Certain characters are not displayed correctly ? Press the e key to change the set of characters. Smart picture and sound controls The eco mode is intended to lower power consumption of the TV and to improve picture quality of low quality digital sources. The personal mode is redefined with the settings of the picture and sound menus after you have changed any of the settings. The remote control is no longer working ? The indicator on the TV set no longer flashes when you use the remote control ? Replace the batteries. Standby When you switch the TV set on it remains in standby mode and Locked is displayed when you use the keys on the TV set ? The Child Lock function is switched on (p. 6). If the set receives no signal for 15 minutes, it automatically goes into standby mode. To save power, your television is fitted with components that give it a very low power consumption when in standby mode (less than 1 W).We adwise to switch off the TV overnight instead of leaving it on standby.You save energy. Still no results ? Switch your TV off and on again once. If your TV set breaks down, never attempt to repair it yourself, contact the after-sales service. Cleaning the set Only use a clean, soft and lint-free cloth to clean the screen and the casing of your set. Do not use alcohol-based or solvent-based products.

English EMG 3111 256 1582.3

Glossary
RGB signals:These are 3 Red, Green and Blue video signals which directly drive the red, green and blue emitters in the cathode ray tube. Using these signals provides better picture quality. NICAM sound: Process by which digital sound can be transmitted. System: Television pictures are not broadcast in the same way in all countries.There are different standards : BG, DK, I, and L L�.This is not to be confused with PAL or SECAM colour coding. Pal is used in most countries in Europe, Secam in France, Russia and most African countries. The United States and Japan use a different system called NTSC. 100Hz: Conventional televisions (50 Hz) produce a visible image flicker.Thanks to 100 Hz technology, the scanning frequency is doubled. It is visually more comfortable and the flickering effect is reduced. 16:9: Refers to the length / height of the screen.Wide screen televisions have a ratio of 16/9 and conventional TV sets have a ratio of 4/3.

12