CONTROL PANEL
A. Speed selector switch. B. Light switch.
4
1
O1234
A
B
OI
2
1. 2. 3. 4.
3
small amount of steam and fumes
Control panel Grease filters (behind the extractor grille) Lighting unit Pull-out steam deflector
medium amount of steam and fumes
large amount of steam and fumes
Removing and renewing or washing the grease filter Fig. 1-2:
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector. 3. Remove the extractor grilles (Fig. 1). 4. Remove the device securing the grease filter (Fig. 2). 5. Remove the dirty grease filter. 6. After the grease filter has been renewed or cleaned (depending on model), remount in reverse order, making sure the entire extraction surface is covered.
OPEN
CLOSED
OPEN
Fig.1
CLOSED
Fitting or renewing the carbon filter Fig. 3:
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector. 3. Remove the extractor grilles. 4. If the carbon filter is already fitted and needs renewing, press the release buttons (b) and pull the filter out downwards. 5. If the filters are not fitted. a. Locate the carbon filter under the top clips. b. Secure in place with the bottom clips. 6. Refit the extractor grille.
Fig.2
a a
Replacing bulbs
1. Unplug the appliance or disconnect the mains power supply. 2. Pull out the steam deflector. 3. Open the back extractor grille. 4. Remove the burnt-out bulb. Replace using 40W max (E14) bulbs only. 5. Refit the extractor grille.
