Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
Multiple-unit System Operation
9. Adjust the INPUT control on deck 2 of the master so the meter reading is around 0 dB. Balance the left and right input levels with the REC BAL control. 14. To continue to record, press the � button once more on deck 2 of the master.
10. Set the DOLBY NR switch on deck 2 of the master to the desired position.
15. To terminate recording, press STOP on deck 2 of the master.
All the slave decks con�gure themselves to the level and balance on deck 2 of the master. Settings on the individual decks are overridden. 11. To start recording, press the � button on deck 2 of the master.
If the tape on deck 2 of the master reaches the end of the forward side before any tapes on the slaves, recording continues on these tapes up to the end of their forward sides. You can interrupt recording on all the decks by pressing STOP on deck 2 of the master. 12. When all the tapes reach the end of their forward sides, hold down RECORD and press PAUSE on deck 2 of the master to put all the decks into Record Ready mode.
13. Press the � button on deck 2 of the master so that all the tapes are ready for recording on their reverse sides.
