Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Surface Cq)oking
IGNITION SYSTEM TO LIGHT SEALED BURNER ADDITIONAL INFORMATION Your range will feature pilotless ignition; a spark from the ignitor lights the burner. The ignitor is located at the back side of each surface burner, t. Place utensil on burner grate. 2. Push in and turn knob to the LITE position. After the burner lights, turn the knob to the desired flame size. � When the range is first installed, the pilots may be difficult to light due to air in the gas line. To bleed off air from the line, hold a lighted match next to the burner and turn knob on. When the proceed as directed. � Be sure all surface controls are set in the OFF position prior to supplying Ignitor REAR ViEW OF SEALED BURNER gas to the appliance.
_ NOTE: The knob on your appliance may not look like the knob in this illustration, but it will operate as described in this booklet,
burner lights, turn the knob go out � CAUTION: If flame should off and during a cooking operation, turn the burner off. If gas has accumulated and a strong gas odor is detected, wait 5 minutes for the gas to dissipate before relighting burner. � You may hear a "popping" sound on LP gas when the surface burner is turned off. This is a normal operating sound of the burner. � If a knob is turned very quickly from HI to LO setting, the flame may go out, particularly if the burner is cold.
ABOUT DUAL
SEALED
THE
SURFACE
PURPOSE
BURNERS
HI SPEED
_ (if equ,pped)
BURNER
" _ _O_er 'Y
FLAME
_dJ_t_d bu met with c,ea_ ___
Some models feature one or two special HI SPEED sealed burners. Refer to the rating plate to determine if your appliance features the HI SPEED burners. See inside front cover for tocation of rating plate,
ports will light within a few seconds, � On natural gas, the flame will be blue with a deeper blue core; there should be no trace of yellow in the flame. A yellow flame indicates an improper mixture of airgas. This wastes fuel, so have a serviceman adjust the mixture if a yellow flame occurs, � On LP gas, some yellow tipping is acceptable. This is normal and adjustment is not necessary. _'IP'__
LOCATION OF BURNERS:
HIGH BURNER
If this occurs, turn the knob to the OFF position. Wait several seconds, then light the burner again.
