ASSEMBLY
Fitting the hand guard and loop handle
(325HDA55,323HE3,325HE3) It is important that the hedge trimmer is laid on a �at surface when you �t the cutting head. Otherwise the cutting head may not be �tted straight. 1 Fit the cutting head to the shaft. CAUTION! Make sure the drive shaft inside the shaft engages with the recess in the cutting head.
Fitting the cutting head
(325HDA55, 323HE3)
1
Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts. (325HDA55, 323HE3)
2 3 4
Slide the loop handle and hand guard onto the shaft. (325HDA55, 323HE3) Slide the spacer into the slot in the loop handle. Fit the nut and screw. Do not overtighten. 2 Tighten the lower screw �rst, then the upper screw.
Adjusting the harness
(325HE4)
5
Now make a �nal adjustment to give yourself a comfortable working position. Tighten the screw. CAUTION! The loop handle and hand guard must not be �tted behind the arrow marked on the shaft.
You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back. 1 2 3 Put on the harness. Hook the machine onto the harness support hook. Adjust the length of the harness so that the support hook is roughly level with your right hip.
