-VCC * Deflection yoke characteristics: R = 5.5�, L = 7mH fvert = 50Hz
5
ELECTRICAL CHARACTERISTICS (refer to Figure 1 on page 3)
Tamb = 25°C unless otherwise specified, Vcc = ±12V, fvert=50Hz
Symbol +Vcc -Vcc �Vcc Vccstart Iq Iy I13, I12 VOS SVR Flythr Fly thf Pd Fsw Fsw - op Rfreq Parameter Positive supply range Negative supply range Maximum recommended difference between +Vcc and � Vcc Low Vcc detection Quiescent supply current Maximum recommended vertical yoke current Amplifier Input bias current Output Offset voltage Supply voltage rejection Flyback detection threshold (positive slope) Flyback detection threshold (negative slope) Test Conditions Min. +10 -18 Typ. Max. +18 -10 ±4 ±6.5 Input voltage = 0 14 ±1.25 -0.1 Note 1 Note 2 V(14) V(14) -50 82 1.5 0.5 1.1 120 100 7 140 10 160 200 14 +50 Units V V V V mA A
Figure 1. Test and Application Circuit
µA
mV dB V V W kHz kHz k�
Integrated circuit Note 3 Dissipated power Switching frequency R freq = 10k� Switching frequency operative range Frequency controller resistor range Pin 10
Note: 1 Note: 2 Note: 3
Input voltage = 0, measured after the filter (e.g. accross the 470 nF filter capacitor) Supply rejection of the positive or negative power supply. Vcc ripple =1Vpp, f=100Hz, measured on the sense resistor. Power dissipated in the circuit in the case of the application from Figure 1 and the current in the deflection yoke adjusted to 2.5App. The corresponding power dissipated in the vertical deflection yoke is 2.8W.
