Surround loudspeakers There are two surround loudspeakers supplied. One is the active loudspeaker A.The other loudspeaker B is a passive one which has to be connected with the active loudspeaker.
�
4 1 2 3
Connect the active to the passive loudspeaker with the supplied speaker cable 1. Insert the marked wire into the openings of the same coloured connector clips on both speakers. Do not insert the wires too far. The Surround sound loudspeakers can be located behind or to either side of the listener.The front of the loudspeakers do not have to face the listener. Set the position switch 2 to the right if the active loudspeaker is positioned to the right side of the listener, to the left if it is positioned to the left side of the listener (seen from the point of view of watching the TV). Connect the 3,5 mm jack cable with the connector at the back of the active surround loudspeaker and with the black and red REAR R or L outputs at the back of the TV. Connect the active loudspeaker to the mains with the mains cable 3. Switch on the active loudspeaker with the POWER switch 4. The red indicator at the front of the active surround speaker shows that the speaker is in standby. During sound transmission the indicator turns to green. 10-15 min. after the sound transmission of the TV has stopped, the indicator turns back to red to indicate the low power standby. To switch the active speaker off, use the POWER switch.
