PRIVILEG 445.172 0/40542
Instrukcja Obsługi

HINTS
Hints for freezing
To help you make the most of the freezing process, here are some important hints: � � the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; the freezing process takes 24 hours. No further food to be frozen should be added during this period; prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required; � � wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt; it is advisable to show the freezing-in date on each individual pack to enable you to keep tab of the storage time; The symbols on the drawers show different types of frozen goods. The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. � do not put carbonated liquids (fizzy drinks, etc.) in the freezer compartment as they may burst.

Fix cover (Hc) on guide (Ha) until it clips into place.
Ha

Hints for storage of frozen food
To obtain the best performance from this appliance, you should: � � make sure that the commercially frozen foodstuffs were adequately stored by the retailer; be sure that frozen foodstuffs are transferred from the foodstore to the freezer in the shortest possible time; not open the door frequently or leave it open longer than absolutely necessary. Once defrosted, food deteriorates rapidly and cannot be refrozen. Do not exceed the storage period indicated by the food manufacturer. Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.
PR33

Hc

�

� � �

8mm

Ha Hb
PR167

�

�

�

Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.

Hb
PR168

Fix cover (Hd) on guide (Hb) until it clips into place.

Hb

Hd
PR167/1

18

23