Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Removing
the base grille
Condenser coils
To remove the grille: 1. Open refrigerator door. 2. Pull base grille forward to release the support tabs from the metal clips. 3. Do not remove Tech Sheet fastened behind the grille. To replace the grille: 1. Line up grille support tabs with metal clips. 2. Push firmly to snap into place. 3. Close refrigerator door. See cleaning instructions for defrost pan and condenser coils on page 15.
Reversing
the door swing
You can change the hinges on your refrigerator so the doors open the other way. Refer to the instruction sheet included with your refrigerator.
Understanding
the sounds
Water
you may hear
sounds
Your new refrigerator may make sounds that your old one didn�t. Because the sounds are new to you, you might be concerned about them. Don�t be. Most of the new sounds are normal. Hard surfaces like the floor, walls and cabinets can make the sounds seem louder. The following describes the kinds of sounds that might be new to you, and what may be making them.
When the refrigerator stops running, you may hear gurgling in the tubing for a few minutes after it stops. You may also hear defrost water running into the defrost water pan.
Running
sounds
Your refrigerator has a high-efficiency compressor and motor. It will run longer than older designs. It may even seem to run most of the time.
Slight
hum,
soft
hiss
You may hear the refrigerator�s fan motor and moving air.
Clicking
or snapping
sounds
The thermostat makes a definite click when the refrigerator stops running. It also makes a sound when the refrigerator starts. The defrost timer will click when the defrost cycle starts.
