GENICOM 5050
Instrukcja Obsługi

IPDS 3. While in the IPDS menu, press the � (left) or � (right) menu IPDS BC Stagger browse pushbutton until IPDS BC Stagger is displayed in the lower right corner of the LCD. IPDS BC Stagger 4. Press the � (down) menu browse pushbutton to access the IPDS Enable< BC Stagger options. 5. Press the � (left) or � (right) menu browse pushbutton until the desired option is displayed. Press the Select pushbutton to enable or disable an option. The < symbol will immediately follow an enabled option.

IPDS BC Density
This menu option is used to select the IPDS BC Density setting for IPDS. This option is used to select the barcode print density in IPDS emulations. Low is 72 dots horizontally by 72 dots vertically and High is 144 dots horizontally by 144 vertically. Use the following procedure to select this option: IPDS 1. While in the IPDS menu, press the � (left) or � (right) menu IPDS BC Density browse pushbutton until IPDS BC Density is displayed in the lower right corner of the LCD. IPDS BC Density 2. Press the � (down) menu browse pushbutton to access the IPDS Low< BC Density options. 3. Press the � (left) or � (right) menu browse pushbutton until the desired option is displayed. Press the Select pushbutton to enable or disable an option. The < symbol will immediately follow an enabled option.

IPDS GR Density
This menu option is used to select the IPDS GR Density setting for IPDS. Used to select graphic print density in IPDS emulations. Low is 72 dots per inch and High is 144 dots per inch. Higher density means better print quality, but at a lower speed. Use the following procedure to select this option: IPDS 1. While in the IPDS menu, press the � (left) or � (right) menu IPDS GR Density browse pushbutton until IPDS GR Density is displayed in the lower right corner of the LCD. IPDS GR Density 2. Press the � (down) menu browse pushbutton to access the IPDS Low< GR Density options. 3. Press the � (left) or � (right) menu browse pushbutton until the desired option is displayed. Press the Select pushbutton to enable or disable an option. The < symbol will immediately follow an enabled option.

IPDS Image Density
This menu option is used to select the IPDS Image Density setting for IPDS. This is used to select image density/quality in IPDS emulations. Low is 72 dots per inch and High is 144 dots per inch. Higher density means better print quality, but at a lower speed.

GEK-99044

5-55

Chapter 5 Using the Set Up Menu