SHARP 66GF-63H
Skrócona Instrukcja Obsługi

1

SUPPLIED ACCESSORIES

2
66GF-63H
COLOUR TELEVISION OPERATION MANUAL

TYPICAL CONNECTIONS (continued)
BACK OF TV

4

AUTO INSTALLATION
The AUTO INSTALLATION function will tune all available TV stations into your TV. The TV is ready to preset automatically all local channels for you. If you do not intend to use your TV with a VCR then please proceed to stage 4.2

Please read this operation manual carefully before using the colour television. If you require any advice or assistance regarding your Sharp product please visit our web-site www.sharp.co.uk/support. Customers without Internet access may telephone 0990 274277 during office hour.

Mains Socket Outlet AC 220~240 V, 50 Hz SCART Lead (Not supplied) Aerial Lead (Not supplied)

Printed on recycled paper

VCR 1 If the TV is being used with a VCR, turn on the VCR and play back a pre-recorded tape.

Remote control

Operation Manual

RF out

BACK OF VCR

Aerial (Not supplied)

Type-AA Dry Batteries
Aerial in Aerial Lead (Not supplied) Audio/Video

2 Now, press any button on the TV remote control and follow the instructions on the screen, to start Auto Channel Preset.

Pr 01

Fitting the batteries

Mains Socket Outlet AC 220~240 V, 50 Hz

A scart lead (not supplied) is recommended for use with this TV, to obtain the best communication between your TV and VCR, please refer to page-36 of the operation manual.

This tuning process may take several minutes to perform.

Automatic searching and sorting Press the menu button to cancel

Check List:
1. With your thumb nail, pull up the slit as shown. 2. Insert the two batteries as shown. 3. Replace the cover.
G Is the TV connected to G Is the aerial connected

the mains? to the TV?

Note: for Satellite/Cable or digital decoder page 36 of operation manual.

2

TYPICAL CONNECTIONS

3

TURN TV ON FOR THE FIRST TIME
TV set

3 After searching has finished the channels will be stored in the following order: Pr01 - BBC1, Pr02 - BBC2, Pr03 - ITV, Pr04 - CH4... The "Stored programmes" menu will appear on screen and you can change the order of the channels and change or give the channels a four letter name. If you wish to rename the channels, or change the order, refer to the pages 8 and 9, chapter Stored programmes in the Operation Manual If you wish exit from the menu, press the BLUE button.

1 Press the main power button (®) to start the AUTO INSTALLATION. 2 The orange power indicator will light.
Power indicator

Mains Socket Outlet AC 220~240 V, 50 Hz

3 The AUTO INSTALLATION message will appear on your TV screen, and after a time will change for another with electrical connetions
Aerial Lead (Not supplied) Aerial (Not supplied)

Main power button

Note: If you need to repeat the �AUTO INSTALLATION�, please refer to the relevant section on page 28 of the operation manual.

NOTE: IF THE TV CANNOT BE INSTALLED BY
THIS METHOD, PLEASE PHONE THE FOLLOWING NUMBER: 08705 274277

Web-site:www.sharp.co.uk/support

Help Line(office hours only): 08705 274277

Web-site:www.sharp.co.uk/support

Help Line(office hours only): 08705 274277

Web-site:www.sharp.co.uk/support

Help Line(office hours only): 08705 274277