FUNAI 6724DG
Instrukcja Serwisowa

HOW TO INITIALIZE THE TV/DVD/VCR
To put the program back at the factory-default, initialize the TV/DVD/VCR as the following procedure.

< DVD Section >
1. Turn the power on and press [SELECT] button on the remote control unit to put the TV/DVD/VCR into DVD mode. 2. Press [1], [2], [3], [4], and [DISPLAY] buttons on the remote control unit in that order. Fig. a appears on the screen.
"*******" differ depending on the models.

< TV/VCR Section >
1. Use the service remote control unit. 2. Turn the power on. (Use main power on the TV unit.) 3. Press [DISC MENU] button on the service remote control unit to enter the Service mode. (Refer to �How to enter the Service mode� on page 1-7-1.) 4. Press [VOL p] button on the service remote control unit twice, and confirm that OSD indication is �7F = FF.� If needed, set it to become �7F = FF� by pressing [CH. o / p] buttons on the service remote control unit. 5. Confirm that OSD indication on the four corners on TV screen changes from on and off light indication to red by pressing a [DISPLAY] button. (It is necessary for one or two seconds.) 6. Turn the power off by pressing main power button on the TV unit, and unplug the AC cord from the AC outlet.

MODEL : ******* Version : *.** Region : *

EEPROM CLEAR : CLEAR

EXIT: SELECT

Fig. a

3. Press [CLEAR] button on the remote control unit. Fig. b appears on the screen.
"*******" differ depending on the models.

MODEL : ******* Version : *.** Region : * EEPROM CLEAR : OK

EEPROM CLEAR : CLEAR

EXIT: SELECT

Fig. b

When �OK� appears on the screen, the factory default will be set. 4. To exit this mode, press [CH. o / p] or [SELECT] button to go to TV mode, or press [POWER] button to turn the power off.

1-8-1

T1200INT