PHILIPS 6844XL/40
Instrukcja Obsługi

14

ENGLISH

ENGLISH
3

15

C

Brush out hairs from the inside of Razor Head Assembly and hair chamber.

C

7

Remove and clean one cutter and comb at a time.

C

4

Replace the Razor Head Assembly back on razor.

Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.
8

Separate the cutter from the comb. Only brush the cutter in an upward motion. Use the short bristled side of the brush.

Every Two Months: Razor Head
Do not mix up the cutters and combs as the shaving performance may be adversely affected for several weeks before optimal shaving performance is restored.
1

C

9

C 10

Turn razor to Off (O) position, remove plug from outlet and disconnect cord from razor. Press the Razor Head Release Button and remove Razor Head Assembly from the razor unit. Brush the inside of the razor housing. Turn Razor Head Assembly over so that underside is exposed. Turn wheel of frame counterclockwise. Remove the frame and brush clean.

C C C

2

Brush the slots of the comb. For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Norelco Razor Head Cleaner, model RC1776 or alcohol) and lubricated with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).This helps prevent wear of the shaving heads. Replace the cutter and comb into the Razor Head Assembly. Repeat the process for the other two sets of cutters and combs. Replace the frame. Turn the wheel clockwise until it locks into place.

3 4 5

C 11
12 13

6

C 14