Make sure that the amplifier and the 707II are off. Turn the volume at the amplifier to minimum.
1.
5.
To monitor the sound with headphones, plug the phones into the [OUTPUT/ PHONES] jack. Turn power on in the following order: 707II � amplifier.
2.
To power the unit from the AC adapter, insert the small plug of the adapter cable into the [DC 9V] jack on the 707II. Then plug the adapter into an outlet. Connect the guitar to the [INPUT] jack of the 707II, using a mono cable. Connect the [OUTPUT/PHONES] jack of the 707II to the guitar amplifier, using a mono cable.
6.
NOTE
If you turn the 707II on while the amplifier is already powered up, damage to the speaker may result. Always turn power to the amplifier on last.
3. 4.
7.
Raise the volume setting of the instrument and amplifier, and adjust the [OUTPUT] knob on the rear panel of the 707II.
Preparations
You can also use a Y cable to supply the signal in stereo to two amplifiers.