HOO 501 - 541 PRODUCT DESCRIPTION SHEET
CONTROL PANEL
1
4
A. Light switch. B. Speed selector. C. Extractor power indicators.
2
3
C
A
O
O123
1. 2. 3. 4.
Control panel. Grease filter (inside the extractor grille). Light fixture. Steam deflector (pull-out).
B
large amount of steam and fumes
small amount of steam and fumes medium amount of steam and fumes
REMOVING AND REPLACING OR CLEANING THE GREASE FILTER:
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the stream deflector. 3. Open the extractor grille (Fig. A). 4. Remove the grease filter fixing device (Fig. B). 5. Remove the dirty grease filter. 6. After replacing or cleaning the grease filter (depends on model), remount in reverse order, making sure the entire extraction surface is covered.
1 3 2 2
2
4
Fig. A
MOUNTING OR REPLACING THE CARBON FILTER:
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the steam deflector. 3. Open the extractor grille (Fig. A). 4. If a carbon filter is already mounted and needs replacing, press the release buttons (b) and pull the filter out downwards (Fig. C). 5. If the filters are not mounted: - fit the carbon filter onto the rings at the rear (a); - fix the carbon filter at the front by means of the clips (b). 6. Remount the extractor grille.
Fig. B
b a
b a
Fig. C
REPLACING BULBS
1. Unplug the appliance or switch off the mains power supply. 2. Pull out the steam deflector. 3. Open the extractor grille. 4. Remove the burnt-out bulb. Use 40W max (E14) bulbs only. 5. Remount the extractor grille.
