FLUKE 863
Podręcznik Użytkownika

867B/863
Users Manual

Using Single Shot and Glitch Capture Softkeys
Arm < > Exit

1 (Arm) resets the trigger circuit and readies the GMM test tool to capture another single shot waveform or glitch capture transient. �Arm� is selected (highlighted) initially. When the entire waveform is captured, �Arm� reverts to normal contrast. The display shows elapsed time (hh:mm) since arming or, if a trigger subsequently occurred, time between arm and trigger. The time cycles from 00:00 through 99:59 continuously until a trigger is received.

2 and 3 (< and >) move the waveform left or right for viewing (available once the waveform is completely captured). If you press 1 again, the arm cycle starts over, < and > disappear, and the arm-to-trigger time begins at 00:00. Waveform position accomplished with < and > is retained across arm cycles. Six time base divisions prior to the trigger and 19 time base divisions after the trigger can be viewed using < and >, respectively. Refer to Figure 5-4 for an overview of time divisions (on and off screen) that can be examined. 5 (Exit) returns to the View Softkeys. Free Run operation and autoranging are not available during �Single Shot� and �Glitch Capture�. Selecting Touch Hold cancels �Single Shot� and �Glicth Capture�.

5-8