COEMAR 9096
Instrukcja Obsługi

English 6. Installing the unit
mounting
ProSpot LX can operate in any mounting position. The structure from which the unit is hung should be of sufficient rating to hold the weight of the unit, as should any clamps used to hang the unit. The structure should also be sufficiently rigid so as to not move or shake whilst the ProSpot LX moves during its operation. The two mounting holes �13 mm (A) on the base of the ProSpot LX allows the projector to have hook clamps fitted for the purpose of hanging.

safety chains
The use of a safety chain fixed to the ProSpot LX and to the primary suspension structure is highly recommended to protect against the accidental failure, however unlikely, of the primary suspension point. If using an aftermarket safety chain not manufactured by coemar, ensure that it is of a sufficient rating to hold the weight of the unit. The safety chain is attached by means of the two holes B located in the base of the unit as shown in the diagram.

movement
The projector has an articulated movement of 530° in the base and 284° through its yoke; DO NOT obstruct the articulated movement in any way.

protection against liquids
The projector contains electric and electronic components that must not come into contact with water, oil, or any liquid.

risk of fire
Each fixture produces heat and must be installed in a well-ventilated position. The minimum recommended distance from flammable material is 0.5m. Minimum distance from the object being illuminated is 2m.

forced ventilation
You will note that the projector�s housing contains several air entry points and fan outlets, positioned both on the head and the base of the unit; under no circumstances should any of these points be obstructed! Obstruction of any of these points will result in the over-heating of the unit, detrimentally and seriously affecting the proper operation of the ProSpot LX. On this point, refer to section 18 �Electronic motor alignment�, subsection temperature (temp).

8