The amount of cleaning solution in the transparent cleaning reservoir is visible on both sides of the Jet Clean System. When the level gets low, refill with Philips Norelco HQ200 Cleaning Solution.
Jet Cleaning the Razor
� If the razor does not contain enough power for one (1) shave, the Jet Clean Cleaning System may not work properly. Charge the razor in the Jet Clean System before using the it to clean your razor.
� The cleaning solution is automatically supplied from the reservoir to the cleaning canister through a special mechanism in the reservoir cap.
C
C
7
Replace cap on reservoir (2) and turn clockwise (1) making sure cap is screwed on securely.
Connect the small plug to the Jet Clean System. Connect the charging plug into any 100V to 240V AC outlet. Use only the charging plug provided. The razor holder automatically moves up to the highest position. 2. Place the Jet Clean System on a flat, level surface. Fill the cleaning reservoir with cleaning solution (see �Preparing Jet Clean System For Use�). Remove protective razor head cap from razor.
1
� The cleaning solution may foam if the reservoir level is too low.Discard remaining solution,rinse the reservoir with warm water from the tap and refill with new cleaning solution. � If you clean your razor every day, you should refill the reservoir approximately once a month.
C C
3
C
8
Carefully lower the cleaning reservoir back into the Jet Clean System making sure the reservoir is properly aligned with the base unit.
Place the razor head side down in the razor holder so that the razor head fits into the configuration shown inside the Jet Clean System. Gently press the base of the razor towards the back of the Jet Clean System so that the razor base fits snugly in place. Lock the razor into place by pushing the lever down completely. The charging light will blink to indicate the razor automatically begins to charge.
