PIONEER A-209/SDFXJ
Instrukcja Obsługi

CONNECTIONS

CONNECTING THE SPEAKER CORDS
1. Strip off the vinyl covering and twist the tip of the wire core.
10mm

CONNECTING THE INPUT/OUTPUT CORDS
Connect the white plug to the L (left) channel, and the red plug to the R (right) channel. Be sure to push the plugs securely. Left channel

Twist the wire core

White plug

L

2. Loosen the knob and insert the wire core into the terminal hole. 3. Tighten the knob to fix the wire core in place. 2 1

Right channel

R
Red plug

\
3

AC POWER CORD
NOTE:
Do not allow any of the cord conductors to protrude from the terminals or touch any other conductors. Malfunctioning or breakdowns may occur when conductors come into contact with each other.
Plug in the power cord first to the amplifier and then to the wall outlet after you have finished hooking up the rest of your equipment.

CAUTION!
� Do not use any other power cord than the one supplied with this unit. � The amplifier should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g. when on vacation.
Please use the correct cord and plug for your region.

Speaker Impedance [A-209]
When speaker systems are connected to only SPEAKERS A or SPEAKERS B terminals, such speakers should have rated impedance in the range of 4�16 �. When speaker are connected to both A and B terminals, they should have a rated impedance in the range of 8 �32 �.

For regions with two pin flat-bladed plug and 200 volts or greater power supply European two pin plug with two pin flat-bladed converter plug (for 200 volts or greater power supply) For Taiwan exclusively Taiwanese two pin flat-bladed plug Make sure the voltage selector has been switched to the 110 V position before plugging in the AC power cord.

[A-109]
The speaker systems used should have a rated impedance in the range of 6 - 16 �.

5

English