ONKYO A905TX
Instrukcja Obsługi

Connecting to components other than the Separate Collection Series
Connecting the cables
connec-

If your other components are made by ONKYO and those components are equipped with tors, you can control the -connected components with the supplied remote controller.

Before connecting � The unit must be connected in the system hookups for control operations. � Each component has two connectors. There is no difference between these connectors. � The components may be connected in any order. � The hookups on the previous page are necessary independently of the system hookups. The illustration below is an example of a hookup.

Connections
Tuner

Amplifier � this unit
cable (supplied with every ONKYO component that has connectors except for the amplifier and receiver)

MD recorder

Stereo cassette tape deck

CD player

AC outlet connection
You can connect the power cord from another audio device to the rear of the A905TX. Since the AC outlet on the unit is a SWITCHED type outlet, you can use the POWER switch to turn on/off the power to both the A-905TX and the connected audio device. The shape and capacity of the AC outlet may differ depending on the area of purchase. Make sure that the capacity of other components connected to this unit does not exceed the capacity that is printed on the rear panel.
OUT(REC) IN(PLAY)

L

CAUTION:
SPEAKER IMPEDANCE 4 OHMS MIN./SPEAKER

L

L

SPEAKERS
R R

TUNER LINE/DVD
OUT(REC) IN(PLAY)

TAPE

REMOTE CONTROL OUT(REC) IN(PLAY)

R

L
AC OUTLET

R

AC 230-240V

CDR/PC

CD

MD

OUT

PROCESSOR

IN

SUBWOOFER PRE OUT

50Hz SWITCHED 100W MAX.

230-240 V, 50 Hz models

120 V, 60 Hz models

Capacity is 100 watts.

Capacity is 120 watts.

14