WHIRLPOOL ACQ214XM0
Instrukcja Obsługi

To operate air conditioner with remote control
POWER ON/OFF

AutoCool

Cool

Turbo

Fan Only FAN SPEED Power Saver

High

NOTE: Two AA batteries (not included) power the remote control. Replace batteries after six months of use, or when the remote control starts to lose power. Be sure to install batteries with correct polarity.

To select the mode: Press the AutoCool, Cool, Fan Only, or Power Saver button. When air conditioner is operating in AutoCool mode, fan speed is adjusted automatically. When air conditioner is operating in Fan Only mode, fan speed is automatically set at Turbo. When air conditioner is operating in Cool or Power Saver mode, you can adjust the fan speed.

AutoCool

Cool

Fan Only

Power Saver

Low

Turbo

To select the fan speed (in Cool or Power Saver mode only): Press the Turbo, High or Low button.
Temp / Time Timer

High FAN SPEED Low

To set Timer for a 1 to 24 hour delay until air conditioner turns on (air

Timer

To turn the air conditioner on or off: Press the POWER ON/OFF button. To raise the temperature: Press thevbutton. Each time you press or hold thevbutton, the temperature will go up 1° until it reaches 86°F (30°C).

POWER ON/OFF

conditioner must be in OFF mode): 1. Press the Timer button. 2. Press thevbutton to change delay time (1 to 24 hours). 3. Press the Timer button again or wait 10 seconds. To set Timer for a 1 to 24 hour delay until air conditioner turns off (air conditioner must be in ON mode): 1. Press the Timer button. 2. Press thevbutton to change delay time (1 to 24 hours). 3. Press the Timer button again or wait 10 seconds.

Temp / Time

To lower the temperature: Press thewbutton. Each time you press or hold thewbutton, the temperature will drop 1° until it reaches 64°F (18°C). NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.

6